7 Things of Protection and maintenance you Must Know when using Laser/CNC Machine

The key to making the laser equipment work properly and stable is to do the daily maintenance and maintenance of the equipment. Good equipment maintenance can not only extend the service life of the machine, reduce the equipment failure rate, but also improve product quality. In order to make better use of this equipment, the following is a brief introduction to the daily maintenance and precautions of laser equipment:

1. Ground connection

Because the company's equipment contains sensitive power devices such as switching power supplies, laser power supplies, and filters, these components generate a certain degree of static

Laser machine manufacturer

interference during use. In order to minimize static interference and reduce a series of faults caused by static electricity, the following points should be noted before installing the equipment:

1.1 Whether the voltage is 220V if it is out of range or unstable, the regulator should be installed.

1.2 Whether the power socket is wired according to the left ‘zero’ right ‘fire’ standard, and the ground terminal should be reliable and completely grounded. If not, adjustments should be made.

1.3 Is there a ground wire that is reliably grounded at the customer's site (or an iron bar longer than one meter hits the ground and is completely grounded).

The equipment can be installed when the above conditions are met. When installing the equipment, due to the limited current capacity of the company's plug-in, do not install too much electrical equipment that is not related to the machine. In order to protect the personal safety of the operator and the ground wire of the normal working machine of the equipment, it must be grounded reliably under any circumstances.

2. Before starting the water, you must first, pass the water.

Also, check the water circulation during the working process of the machine to ensure the normal water circulation in the laser tube and protect the normal use of the laser tube.

3. Boot sequence

Follow the order of the machine's power on/off: the first turn on the water pump (water cooler), then turn on the power switch, and finally turn on the laser switch. Turn off the laser switch, turn off the power switch, and finally turn off the water pump (water cooler).

4. Control the temperature of the laser tube

Control the temperature of the water in the laser tube, generally, do not exceed 35 degrees. When using the machine in winter, drain the water in the tube to prevent freezing of the laser tube.

5. Cleaning of the lens

Keep the machine clean, especially the lens. If the lens is dirty, it will affect the reflection efficiency of the light, the processed sample and the life of the lens. When the lens is wiped, wipe it with a cotton swab and dry alcohol to prevent rubbing. The surface of the lens.

6. Pay attention to fire prevention

Do not place flammable or explosive materials in the laser reflection area and around the machine. Do not place reflective items on the platform.

7. Worker Management:

  During the processing, the operator must not leave the machine, always pay attention to the working state of the machine, in case of abnormal conditions, please immediately shut down the power.

AMOR CNC LASER 

www.amorlaser.com